1. Follow the general cutting machine operation procedures. Strictly follow the laser starting procedure to activate the laser.

2. Operators shall refer to all the instructions or receive training from our customer service staff to be familiar with the structure and performance of the equipment and master the relevant knowledge of the operating system.

3. Wear labor protection products according to regulations, and wear protective glasses in the vicinity of the laser beam.

4. Do not process a material without knowing whether it can be illuminated or heated by a laser to avoid the potential hazards of smoke and steam.

5. When the equipment is started, the operator shall not leave the post or leave the person to watch. If you do need to leave, please stop the machine or cut off the power switch.

6. Keep a fire extinguisher within easy reach; Close the laser or shutter when not processing; Do not place paper, cloth, or other flammable materials near unprotected laser beams.

7. If any abnormality is found in the process of processing, stop the machine immediately, troubleshoot the problem in time or report to the supervisor.

8. Keep the laser, bed and surrounding clean, orderly, no oil, workpiece, plate, waste according to the regulations of stacking.

9. When using gas cylinders, avoid damaging the welding wire to avoid leakage accidents. Cylinders shall be used and transported in accordance with the cylinders monitoring requirements. Do not expose the cylinder to sunlight or near a heat source. When opening the bottle valve, the operator must stand at the side of the bottle opening.

10. Check the water level of the water cooler before turning on the power supply. Do not open the water cooler when there is no water or the water level is too low to avoid damage to the water cooler. Do not squeeze or step on the water cooler inlet and outlet pipe, keep water smooth.

11. When the temperature is below 0℃ and the machine is shut down for a long time, the cooling water in the water cooler, laser and water pipe should be discharged to avoid freezing of the cooling water due to low temperature, resulting in damage to the equipment and pipe.

12. Check the protective lens in the laser cutting head once a day. When the collimator or focusing lens needs to be removed, record the removal process, paying special attention to the mounting direction of the lens, do not install the wrong.

13. The equipment will produce a lot of smoke and dust when cutting some plates. The outlet pipe of the fan should be led out of the room or equipped with an air purification device. In addition, operators should wear dust masks.

14. During maintenance, please comply with the high pressure regulations. Maintenance should be performed every 40 hours or weekly, every 1000 hours or every 6 months according to regulations and procedures.

15. The new workpiece program input, should be put into trial operation, and check its operation.

16. When working, pay attention to the operation of the machine tool to prevent the cutting machine from leaving the range of travel or causing accidents due to collision.